you are here: home > circuit categories > tools and measuring > air flow detector

Air Flow Detector electronic circuit diagram

Air Flow Detector electronic circuit diagram

This simple circuit uses an incandescent lamp to detect airflow. With the filament exposed to air, a constant current source is used to slightly heat the filament. As it is heated, the resistance increases. As air flows over the filament it cools down, thus lowering it's resistance. A comparator is used to detect this difference and light an LED. With a few changes, the circuit can be connected to a meter or ADC to provide an estimation on the amount of air flow.

Parts:

R1 100 Ohm 1/4W Resistor
R2 470 Ohm 1/4W Resistor
R3 10k 1/4W ♦Resistor
R4 100K 1/4W Resistor
R5 1K 1/4W Resistor
C1 47uF Electrolytic Capacitor
U1 78L05 Voltage Regulator
U2 LM339 Op Amp
L1 #47 Incandescent lamp with glass removed (See "Notes") LED
MISC Board, Wire, Sockets for ICs, etc.

Notes:

1. The glass will have to be removed from L1 without breaking the filament. Wrap the glass in masking tape and it in a vise. Slowly crank down until the glass breaks, then remove the bulb and carefully peel back the tape. If the filament has broken, you will need another lamp. v

Source: Electronics Lab

Bookmark and Share
if you liked this page, please consider sharing it. Thank you!
Circuit categories
Top 15 circuits from Tools and measuring
Similar diagrams
[see all from: Tools and measuring]

Top 15 circuits