Voltage Monitor electronic circuit diagram
Parts List
D1 LED
R1 1.2k Resistor
R2 10k Var. Resistor
U1 UA741 OP AMP
Description
When the input voltage is 0 the LED glows. The LED stops glowing when the voltage rises to the level determined by R2. Reverse + and - pins to reverse operating mode. To set voltage at which LED goes off, (1) Set 0V at input. (2) Set input voltage at desired level. (3) Adjust R2 to point right after LED goes out.
Source: Electronics Lab
if you liked this page, please consider sharing it. Thank you!
Circuit categories
Top 15 circuits from Tools and measuring
Similar diagrams
[see all from: Tools and measuring]
Top 15 circuits
Audio
- Alarms, control, timers
- Tools and measuring
- Power supplies
- Radio
- Light and LED
- Miscellaneous
- Telephone related
- For your car
- PC related
Similar diagrams
[see all from: Tools and measuring]
Top 15 circuits