you are here: home > circuit categories > alarms, control, timers > voltage controlled switch using 555 timer

Voltage Controlled Switch Using 555 Timer electronic circuit diagram

Voltage Controlled Switch using 555 Timer electronic circuit diagram


In this circuit the 555 timer is used in a novel way, as a voltage controlled switch.


The old and omnipresent NE555 can be very good at something it was not meant for: driving relays or other loads up to 200 mA. The picture shows an example circuit: if the input level rises over 2/3 of the supply voltage - it will turn on the relay, and the relay will stay on until the level at the input drops below one third of the supply voltage.

If the relay and D1 were connected between pin 3 and ground, the relay would be activated when the input voltage drops below one third, and deactivated when the input voltage goes over two thirds of the supply voltage.

It is also a nice advantage that the input requires only about 1 uA, which is something bipolar transistors can't compete with. (This high impedance input must not be left open.) A large hysteresis makes the circuit immune to noise. The output (pin 3) can only be either high or low (voltage-wise), and it changes its state almost instantenously, regardless of the input signal shape.

The voltage drop across the NE555's output stage (at 35-100 mA) is 0.3-2.0 V, depending on the way the relay is connected and the exact current it draws. D1 is absolutely vital to the safety of the integrated circuit.

Circuit by Miroslav Adzic - Serbia & Montenegro

source: zen's circuit directory

Bookmark and Share
if you liked this page, please consider sharing it. Thank you!
Circuit categories
Top 15 circuits from Alarms, control, timers
Similar diagrams
[see all from: Alarms, control, timers]

Top 15 circuits